Series 60 Rocker Arm Parts Detroit Diesel Troubleshooting Diagrams
Posted on by
Detroit Series 60 Valve Adjustment Specs. Detroit diesel 60 series 12.7 liter valveadjustmen YouTube To adjust the intake valves, insert a 0.203 mm (.008 in.) feeler gage between the tip of the valve stem and the valve button at the end of the rocker arm Note that on engines with Jake Brake, measure valve lash and injector height before removing any brake housings
Vnt adjust series 60 detroit diesel YouTube from www.youtube.com
Intake valve clearance and fuel injector height are adjusted using an adjusting set screw and locknut located at the valve or injector end of the rocker arm Accurate adjustment of clearance between valve buttons, intake and exhaust valves is important if maximum performance and economy are to be obtained
Vnt adjust series 60 detroit diesel YouTube
Table 12-2a Valve Lash and Injector Height Adjustment Sequence NOTICE: Never set the valves and injector of the same cylinder at the same time Refer to "Removal and Cleaning of One-piece Rocker Cover for Diesel Engines Only" for one-piece, Camshaft timing, valve lash, injector height, and Jake Brake® lash are all very important specifications that must be followed closely in order to optimize the performance and service.
Q&A Detroit 60 Series Torque Specs for Peterbilt 379 JustAnswer. Detroit Series 60 12.7L Valve Adjustment Chart; Series 60 - Section 13.4 Valve Lash for the Series 60G Engine; Series 60 - Section 13.2 Valve Lash, Injector Height (Timing) and Jake Brake® Lash Adjustments; Series 60 - Section 13.3 Engine Tune-Up Procedures for the Series 60G Engine; Series 60 - Section 13.1 Engine Tune-Up Procedures Keywords: 2007, S60, 2008, 2009, Series 60 Created Date: 11/12/2008 2:53:42 PM
Valve Lash Ddec Vi. Camshaft timing, valve lash, injector height, and Jake Brake® lash are all very important specifications that must be followed closely in order to optimize the performance and service. To adjust the intake valves, insert a 0.279 mm (0.011 in.) feeler gage between the tip of the valve stem and the valve button at the end of the rocker arm